Where is the camshaft position sensor located on a 1999 Ford Ranger? On the dipstick side of the engine, in the forward portion of the block, is where the cam position sensor is found on a Ford 4.0 V6.
Table of Contents
- What are the symptoms of a bad crankshaft position sensor?
- How to Replace Camshaft Position Sensor 1993-1999 Ford Ranger?
- Can I replace the crankshaft sensor myself?
- Can you drive with a messed-up crankshaft sensor?
What are the symptoms of a bad crankshaft position sensor?
Your vehicle’s motor control unit won’t be able to adjust the fuel injection or the spark timing whenever the engine speed rises if your crankshaft sensor isn’t functioning properly.
Intermittent stalling is a different symptom frequently connected to a crankshaft position sensor issue.
The crankshaft signal may be interrupted while the engine is running due to problems with the crankshaft position sensor or its wiring, which could lead to an engine stall.
This typically indicates a wiring issue. However, this symptom can also be caused by a malfunctioning crankshaft position sensor.
Engine performance is decreased.
Reduced engine performance will result from a damaged crankshaft position sensor whether or not the check engine light is on. Anything less than optimal timing will lower your overall performance, whether it be default values or completely incorrect values.
Trouble starting the car.
Starting problems are the most frequent sign of a defective or failing crankshaft position sensor. The crankshaft position sensor keeps track of the crankshaft’s position, speed, and other elements that are crucial for starting the engine. The car might start intermittently or not at all if the crankshaft position sensor isn’t working properly.
Check Engine Light
A check engine light is the most typical sign of a bad crankshaft position sensor. The good news is that your ECM has returned to default measurements if you have a check engine light.
Even though it may result in a few performance issues, this should help stop further damage from happening. However, the issue will only get worse if you put it off for too long.
The engine vibrates or misfires.
A stuttering sound or sensation in the engine could indicate that the crankshaft position sensor is malfunctioning, which could result in misfired cylinders.
A cylinder will misfire if the crankshaft position sensor isn’t functioning properly because it can’t tell where the pistons are in the engine.
Although faulty spark plug timing is another possibility, the crankshaft sensor is more likely to be the culprit if the spark plugs are examined.
How to Replace Camshaft Position Sensor 1993-1999 Ford Ranger?
Can I replace the crankshaft sensor myself?
Although the crankshaft position sensor is a fairly complex piece of machinery and you might be apprehensive about replacing it yourself, you shouldn’t be.
You can replace your own crankshaft sensor with the right tools, some work, and clear instructions.
How much does it cost to replace a crankshaft sensor?
Crankshaft position sensor replacement typically costs between $175 and $230. Between $93 and $117 is the estimated range for labor costs, while $82 to $113 is the range for part costs. Taxes and other fees are not included in this range, nor are your particular vehicle or geographic location taken into account.
How long does it take to fix a crankshaft sensor?
My labor guide estimates that it will take just under 1.5 hours to replace the sensor, and the part itself costs about $50.
Can you drive with a messed-up crankshaft sensor?
It should be safe to drive if the engine appears to be operating normally as it did before. It is NOT OK to drive it all without risk of damage, though, if the engine begins to misfire (you would notice a flashing check engine light).